SCW pump no2 and electric motor
Marine pump vibration analysis of SCW pump no2 identified progressive bearing wear. Although fresh grease reduced the bearing envelope signal, the fault peaks remained visible in the FFT spectra. Bearing replacement subsequently confirmed our diagnosis: the crew found worn bearings, and follow-up spectra no longer showed the bearing wear frequency peaks.
Initial vibration analysis identified bearing wear
The crew performed measurements on the SCW pump no2 and its electric motor in June 2026. During analysis, we observed increased bearing envelope values on the pump. The highest value occurred at point HH3: 391.323 m/s², rounded to 391.32 m/s² in the measurement results.
Most importantly, non-synchronous peaks (BPFI) were present in the FFT envelope spectra. These indicated progressive bearing wear. Based on these findings, our analytical department recommended bearing replacement in report.
Greasing reduced the signal but fault peaks remained
In August 2026, the crew informed us that the bearings had been greased. An external diagnostic check had found no abnormalities, and vibration measurements had been recorded during a port stay. The bearing envelope signal decreased after greasing; however, bearing wear peaks remained visible in the FFT spectra.
Our team therefore repeated the recommendation to replace the bearings. Increased vibration associated with the rotational speed of the machinery was also visible, so we advised checking and retightening all bolts responsible for structural stiffness.
Bearing replacement confirmed the diagnosis
The crew carried out the recommended work and confirmed that the removed bearings were worn. The SCW pump was overhauled and fitted with new bearings. The crew also supplied photographic documentation.
Follow-up measurements showed reduced vibration after the work. The case assessment recorded a reduction in bearing envelope values and the disappearance of bearing wear frequency peaks from the FFT envelope spectra. Further measurements were requested to allow the newly installed bearings to settle in.
Photographic confirmation from the crew
The crew confirmed bearing wear after carrying out the recommendation and supplied the following photographs.
Crew photo documentation of the bearing replacement.
Outcome and cooperation
By implementing the recommendation, a potentially serious pump failure was prevented, as damaged bearings often lead to pump burnout.
We thank the vessel team and crew for their cooperation. Efficient communication and feedback containing specific observations helped us detect machine wear and confirm the diagnosis.
FFT velocity spectra before and after the recommended work

Original before and after FFT velocity spectra for point H3.
FFT bearing envelope spectra before and after replacement
Original before and after FFT bearing envelope spectra for point H3.